Consulta de Guías Docentes



Academic Year/course: 2023/24

571 - Degree in Environmental Sciences

25224 - Water pollution


Syllabus Information

Academic year:
2023/24
Subject:
25224 - Water pollution
Faculty / School:
201 - Escuela Politécnica Superior
Degree:
571 - Degree in Environmental Sciences
ECTS:
6.0
Year:
3
Semester:
First Four-month period
Subject type:
Compulsory
Module:
---

1. General information

The main objective is to provide the student with the scientific and technical knowledge that will allow them to carry out the identification and control of water pollution providing quality training in evaluation, management and environmental planning, having as a reference the protection of health and the environment.

This goal is aligned with some of the SDGs, specifically SDG 6 (6.3 and 6.a) and 12 (12.4).

This subject presents the basics of knowledge on water pollution, in such a way that, complementing the training with the subjects Air Pollution and Soil Pollution, it will provide the students with the necessary theoretical and practical knowledge fundamental to carry out the identification, evaluation, prevention, control and correction of environmental pollution,  in an integrated manner.

It is recommended to have previously taken the subjects Chemical Bases of the Environment, Environmental Administration and Legislation, Environment and Sustainability, Ecology I and II, and Chemical Analysis in the Environment.

2. Learning results

In order to pass this subject, the students shall demonstrate they has acquired the following results:

1. To determine the quality of a water by using indicator parameters.

2. Identify and quantify the pollution generated by an urban or industrial activity and assess the effect it may have on the receiving water environment.

3 Plan a strategy for the prevention and control of water pollution in specific cases.

4. To design a treatment system for urban and industrial wastewater treatment, by means of the selection and sizing of the process units that integrate it.

5. Plan a system for the treatment of drinking water for human consumption and for the regeneration of treated water for subsequent reuse.

 

All of these learning results are part of Sustainable Development Goals 6: Clean water and sanitation and 12: Responsible production and consumption.

3. Syllabus

BLOCK 1. INTRODUCTION TO WATER QUALITY AND POLLUTION

0. Sustainable Development Goals.

1. General concepts on water quality and contamination.

2. Water pollutants.

3. Evolution of contaminants in the receiving environment.

4. Basic water legislation.

BLOCK 2.- WATER TREATMENT TECHNOLOGIES

1. General concepts on water treatment technologies.

2. Homogenization chambers

3. Techniques for the removal of solids, grease, suspended matter and biodegradable matter.

4. Sludge treatment technologies.

5. Disposal techniques for non-biodegradable material.

6. Treatment with resins and membranes.

7. Disinfection.

8. Low-cost technologies.

 

4. Academic activities

Master classes: 30 hours

Theoretical sessions in which the contents of the subject will be explained

Seminars: 5 hours

Resolution of cases related to the topics of the subject.

 

Laboratory practices: 16h

Laboratory sessions related to water characterization and water treatment

Integral practical work: 4h

Group sessions for the realization and presentation of the work on the planning of a global strategy for the control of water pollution in an industrial activity

Visits to facilities: 5h

Visits to water treatment facilities

Autonomous student work (86h) and evaluation (4h)

5. Assessment system

The subject will be evaluated by means of a global evaluation with the following activities to be carried out on the dates established by the center:

Test 1. Individual written test of theory (50% of the final grade)

It will include multiple-choice and theoretical-practical questions (short and essay questions). For its realization, the use of any kind of documentation other than the one provided in the exam will not be allowed.  Minimum grade to average with the rest of the tests: 5

Test 2. Individual written practical exam (30% of the final grade)

It will include short questions on laboratory practices (25%) and seminars (5%). No documentation of any kind other than that provided in the exam will be allowed for its completion.  Minimum grade to average with the rest of the tests: 5

Test 3. Presentation of the integral practical work (20% of the final grade)

It will consist of the presentation and defence of the work done throughout the term. Minimum grade to 

average with the rest of the tests: 5

 

ATTENTION: There is the possibility of taking the evaluation of Tests 2 and 3, before the date of the global test of the evaluation, having attended all the practical and work sessions and submitting the corresponding reports , as students will be informed in the presentation of the subject..

 

If the final grade is ≥ 5 but any of the evaluation test grades are not, the subject will result failed and the grade on the transcript will be "4.0 failed". If tests 2 and/or 3 are passed in the first call,  but the subject is failed, if the student wishes, the grades corresponding to these activities will be kept for the second call of the same academic year.

The success rate in the subject for the last three years is 90.91% (2019-20), 95.45% (2020-2021) and 89.29% (2021-2022),


Curso Académico: 2023/24

571 - Graduado en Ciencias Ambientales

25224 - Contaminación de aguas


Información del Plan Docente

Año académico:
2023/24
Asignatura:
25224 - Contaminación de aguas
Centro académico:
201 - Escuela Politécnica Superior
Titulación:
571 - Graduado en Ciencias Ambientales
Créditos:
6.0
Curso:
3
Periodo de impartición:
Primer cuatrimestre
Clase de asignatura:
Obligatoria
Materia:
---

1. Información básica de la asignatura

El objetivo principal es aportar al estudiante los conocimientos científicos y técnicos que le permitan llevar a cabo la identificación y control de la contaminación de aguas, proporcionándole formación de calidad en evaluación, gestión y planificación ambiental, teniendo como referente la protección de la salud y el medio ambiente.

 

Este objetivo está alineado con algunos de los ODS, en concreto el ODS 6 (metas 6.3 y 6.a) y 12 (meta 12.4).

 

En esta asignatura se presentan las bases del conocimiento sobre contaminación de aguas, de forma que complementando la formación con las asignaturas Contaminación atmosférica y Contaminación de suelos se dota al estudiante de conocimientos teóricos y prácticos fundamentales para llevar a cabo la identificación, evaluación, prevención, control y corrección de la contaminación ambiental, de manera integrada. 

 

Se recomienda haber cursado previamente las asignaturas Bases químicas del medio ambiente, Administración y legislación ambiental, Medio ambiente y sostenibilidad, Ecología I y II y Análisis químico en el medio ambiente.

2. Resultados de aprendizaje

El estudiante, para superar esta asignatura, deberá demostrar los siguientes resultados:

1. Determinar la calidad que presenta un agua mediante la utilización de parámetros indicadores.

2. Identificar y cuantificar la contaminación generada por una actividad urbana o industrial así como valorar el efecto que puede provocar sobre el medio hídrico receptor.

3 Planificar una estrategia de prevención y control de la contaminación del agua en casos específicos.

4. Diseñar un sistema de tratamiento de depuración de aguas residuales urbanas e industriales, mediante la selección y dimensionamiento de las unidades de proceso que lo integran.

5. Planificar un sistema de tratamiento de potabilización de aguas para consumo humano y de regeneración de aguas depuradas para su posterior reutilización.

 

Todos estos resultados de aprendizaje forman parte de los Objetivos de Desarrollo Sostenible 6: Agua limpia y saneamiento y 12: Producción y consumo responsables.

3. Programa de la asignatura

BLOQUE 1. INTRODUCCIÓN A LA CALIDAD Y CONTAMINACIÓN DE AGUAS

0. Objetivos de desarrollo sostenible.

1. Conceptos generales sobre calidad y contaminación de aguas.

2. Contaminantes de las aguas.

3. Evolución de los contaminantes en el medio receptor.

4. Legislación básica en materia de aguas.

 

BLOQUE 2.- TECNOLOGÍAS DE TRATAMIENTOS DE AGUAS

1. Conceptos generales sobre tecnologías de tratamiento de aguas.

2. Cámaras de homogeneización

3. Técnicas de eliminación de sólidos, grasas, materia en suspensión y materia biodegradable.

4. Tecnologías de tratamiento de fangos.

5. Técnicas de eliminación de materia no biodegradable.

6. Tratamiento con resinas y membranas.

7. Desinfección.

8. Tecnologías de bajo coste.

4. Actividades académicas

Clases magistrales: 30 horas

Sesiones teóricas en las que se explicarán los contenidos de la asignatura


Seminarios: 5 horas

Resolución de casos relacionados con el temario de la asignatura

 

Prácticas de laboratorio: 16h

Sesiones de laboratorio relacionadas con caracterización y tratamientos de aguas

 

Trabajo práctico integral: 4h

Sesiones en grupo para la realización y presentación del trabajo sobre planificación de una estrategia global de control de la contaminación de aguas en una actividad industrial

 

Visitas a instalaciones: 5h

Visitas a instalaciones de tratamiento de aguas

 

Trabajo autónomo del alumno (86h) y evaluación (4h)

5. Sistema de evaluación

La asignatura se evaluará mediante evaluación global con las siguientes actividades a realizar en las fechas establecidas por el centro:

 
Prueba 1. Prueba escrita individual de teoría (50% de la nota final)

Incluirá preguntas tipo test y de carácter teórico-práctico (cuestiones cortas y de desarrollo). Para su realización, no se permitirá la utilización de ningún tipo de documentación a excepción de la suministrada en el examen. Nota mínima para promediar con resto de pruebas: 5

 

Prueba 2. Examen escrito individual de prácticas (30% de la nota final)

Incluirá cuestiones cortas sobre las prácticas de laboratorio (25%) y los seminarios (5%). Para su realización no se permitirá la utilización de ningún tipo de documentación a excepción de la suministrada en el examen. Nota mínima para promediar con resto de pruebas: 5

 

Prueba 3. Presentación del trabajo práctico integral (20% de la nota final)

Consistirá en la presentación y defensa del trabajo realizado a lo largo de la asignatura. Nota mínima para promediar con resto de pruebas: 5

 

ATENCIÓN: Existe la posibilidad de realizar la evaluación de las Pruebas 2 y 3, antes de la fecha de la prueba global de la evaluación, habiendo asistido a todas las sesiones prácticas y de trabajo y entregando los informes correspondientes, tal y como se informará a los estudiantes en la presentación de la asignatura.


Si la calificación final es ≥ 5 pero alguna de las notas de las pruebas de evaluación no, la asignatura resultará suspensa y la calificación en acta será de "4.0 suspenso". Si las pruebas 2 y/o 3 son aprobadas en la primera convocatoria de evaluación, pero la asignatura resulta suspensa, siempre que el alumno lo desee, se guardarán las notas correspondientes a estas actividades para la segunda convocatoria del mismo curso académico.

 

El porcentaje de éxito en la asignatura de los tres últimos cursos es de 90.91% (curso 19-20), 95.45% (curso 20-21) y 89.29% (curso 21-22).